Vertical Cantilever Slurry Pumps
R-HDHV Series
Features
FULLY CANTILEVERED
Eliminates submerged bearings, packing, lip seals, and mechanical seals
STANDARD IMPELLERS
Unique double suction impellers; fluid flow enters the top as well as the bottom. This design eliminates shaft seals and reduces thrust load on the bearings.
LARGE PARTICLE
Large particle impellers are also available and enable passing unusually large solids.
BEARING ASSEMBLY
Our maintenance friendly bearing assembly has heavy duty roller bearings, robust bearing housings, and a massive shaft.
CASING
The metal pumps have a heavy walled abrasive resistant chrome alloy casing. Rubber/Polyrethane pumps have molded casing adhered to sturdy metal structures.
COLUMN AND DISCHARGE PIPE
The metal pump columns and discharge pipes are steel, and the rubber/polyurethane columns and discharge pipes are rubber/polyurethane covered.
UPPER STRAINERS
Snap in polyurethane strainers fit in column openings on the smaller sizes and steel strainers on the larger sizes prevent overly large particles and unwanted refuse from entering casing of the pump.
LOWER STRAINERS
Bolt on steel strainers on the metal pump and molded snap on polyurethane strainers on the rubber/polyurethane pumps prevent overly large particles and unwanted refuse from entering casing of the pump.
Briefings
The R-HDHVsw Series pumps are ideal for a variety of submerged suction pumping applications. These pumps operate well in a variety of sump conditions, and can also be readily applied on floating dewatering or other floating pump platforms.
As a true cantilevered pump, the R-HDHVsw Series does not have submerged bearings or seals; thus, eliminating the primary failure mechanism for similarly fielded pump lines.
Maximum
Discharge
25-450mm
Diameter
Flow
Rates
6,000
gpm
Profile:
* Discharge Diameters 40mm to 250mm
* Heads through 160ft (50m)
* Flow-rates through 6,000gpm (1,350m3/h)